What are the steps of band saw installation and debugging?

1. The band saw stands on the basis of a stable band saw. 2. The saw wheel is the main component of the woodworking band saw machine. The upper and lower saw wheels must be adjusted on the vertical plane. The outer diameter edge of the saw wheel should be perpendicular to the center of the frame saw mouth. The lower saw wheel is adjusted by countersunk bolts on the suspension bearing bracket. Adjustment of the upper saw wheel: loosen the locking bolt behind the upper saw wheel bearing seat, rotate the adjusting screw, and the upper saw wheel bearing seat moves relative to the body so that the upper saw wheel can be adjusted on the horizontal plane according to the position of the lower saw wheel. 3. The upper wheel lifting device is used to correctly adjust the center distance of the two wheels so as to tighten and load according to the length of the saw blade. Push the handle wheel forward and turn the handwheel. The upper saw wheel can rise or fall in parallel. If the inclination of the upper saw wheel needs to be adjusted, pull the hand wheel back to separate the pin on the hand wheel shaft from the left bevel gear. At this time, only the right bevel gear of the rotating wheel rotates and can be used as the right guide rail through the rod. The column is lifted separately to adjust the inclination angle. This not only tightens the saw, but also prevents the saw blade. 4. In order to ensure the balance of saw blade tension during sawing, woodworking band saw has lever tension. The weight of the hanging heavy hammer must be increased or decreased according to the width and thickness of the saw blade, and the pulling force of the saw blade is generally not less than the recommended value. 5. The band saw safety device is used to prevent serious damage caused by swinging blades at high speed. Saw cards may often come down with the size of sawn wood. The saw card is made of hardwood and the pad is suitable, and the blade's life ends along the wood grain direction. The blade groove and clip are generally preferably about 0.15-0.25mm .. 6 Woodworking band saw machine is equipped with backing plate device. Adjust the distance between the backup plate and the saw blade to saw plates and talents of various specifications.